Powering on the switch, Obtaining documentation – H3C Technologies H3C S10500 Series Switches User Manual
Page 18
15
•
Flow control—None.
Powering on the switch
1.
Make sure the power cords are connected correctly to the power source, and the power source is
supplying power correctly.
2.
Turn on the circuit breakers for the power modules.
3.
Power on the switch.
4.
Verify that the LEDs on the switch are in the states as described
. For more information
about the LEDs, see H3C S10500 Switch Series Installation Guide.
Table 4 LED status when the switching is operating correctly
Card LED
Status
MPU
LSU1SUPB0
LINK Steady
on
ACT
Flashing or off
OK Steady
on
FAIL Off
RUN Flashing
ALM
Flashing or off
•
LSUM1MPU06B0
•
LSUM1MPU10C0
LINK/ACT
Flashing or steady on
OK Steady
on
FAIL Off
RUN Flashing
ALM
Steady on or off
Switching fabric module
RUN
Flashing or steady on
ALM Off
Power module
Power input
Steady green
Power output
Steady green
Fan tray
OK Steady
on
FAIL Off
Obtaining documentation
Take the following steps to get related documents from the H3C website at www.h3c.com.
1.
Go to http://www.h3c.com/portal/Technical_Documents.
2.
Choose the desired product category and model.