H3C Technologies H3C S12500-X Series Switches - Manual (Page 14)

8
Setting the maximum number of flow entries
You can set the maximum number of flow entries that each extensibility flow table supports. When the
maximum number is reached, the OpenFlow instance does not accept new flow entries for that table and
sends a deployment failure notification to the controller.
To set the maximum number of flow entries that each extensibility flow table supports:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OpenFlow instance
view.
openflow instance instance-id N/A
3. Set the maximum number of
extensibility flow entries.
flow-entry max-limit limit-value
By default, an OpenFlow
extensibility flow table supports at
most 65535 flow entries.
Configuring inband management VLANs
Inband management VLANs of an OpenFlow instance are used to establish connections between the
OpenFlow instance and controllers.
The data packets within the inband management VLANs of an OpenFlow instance are not forwarded
through OpenFlow. The ports that are assigned only to inband management VLANs are not OpenFlow
ports. Before configuring inband management VLANs, you must plan the network.
To configure inband management VLANs:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OpenFlow
instance view.
openflow instance instance-id N/A
3. Configure inband
management VLANs. in-band management vlan vlan-list
By default, no inband management VLAN
is configured.
The inband management VLANs of an
OpenFlow instance must be within the list
of the VLANs that are associated with the
OpenFlow instance.
This feature is applicable only to
OpenFlow instances in VLAN mode.
Forbidding an OpenFlow instance to report the specified types
of ports to controllers
Step Command Remarks
1. Enter system view. system-view N/A