Ensemble Designs BrightEye 3 Analog to SDI Converter with TBC and Frame Sync - Manual (Page 10)

BrightEye 3 Analog to SDI Converter with TBC/FS
The following status items are also reported for the unit:
• Input Pres – reports the presence and detected line rate of the video input.
• Ref Pres – reports the reference input status.
Proc Menu
A video processing amplifier allows the adjustment of parameters for the analog
input signal.
The Proc menu provides the following video processing controls:
• Gain – adjusts the overall gain of the analog video signals passing through
the converter from 50 to 150%. The front panel indicator will light green
when the gain is set to its nominal or unity setting.
This is the setting which will produce correct digital output levels from an
analog input source which itself is at proper level. The indicator will show
red whenever the control is adjusted either higher or lower than the
nominal setting.
• Chroma – adjusts the percentage of chroma from 50 to 150%. There is no
front panel control or indication of this setting.
• Pedestal – adjusts the pedestal level of the signal +/- 5 IRE.There is no
front panel control or indication of this setting.
• Hue – adjust the amount of hue +/- 90 degrees in 525 mode only. There is
no front panel control or indication of this setting.
All values can be reset to nominal by selecting the Default button next to
the control.
BrightEye-10