Ensemble Designs BrightEye 90-F HD Up/Down Cross Converter and ARC with AES Audio and Optical Output - Manual (Page 25)

TM
BrightEye 90-F
BrightEye 90-F - Page 25
Mixer A
Use the
Mixer A and Mixer B menus to control the audio mixing and shuffling of
the module. Each output bus assignment will be indicated by a green box.
For Channels 1 – 4, use the Mixer A menu as follows:
• Outputs 1-4 – provides Peak/VU status, with the same methodology as the front
panel VU indicators, but on a per-channel basis, rather than per- channel pair.
Peak/VU indicators illuminate red when the audio level on that channel exceeds
the headroom level set by the user with the Peak Indicator control in the Audio
Config Menu Additionally, the VU indicator illuminates orange when the output
is above 0 VU, illuminates green when the output is above -20 VU, and doesn’t
illuminate when the output is below -20 VU.
• Inputs Ch 1-4 – these controls provide mixing and output level control for audio
channels 1 to 4 of the selected audio group. The text field at the top of the control
indicates the amount of gain applied to the channel in dB. The gain level can be
adjusted from -70 dB to +12 dB by moving the vertical slider control, using the up
down arrows, or entering a desired level directly in the field and pressing the
Enter key on your computer. On the right hand side of the control are Output
Bus Ch Assign buttons. These buttons control which analog output channel the
audio channels are mapped to.
The Tie function is used for stereo operation where gain of a pair of channels is
usually desired to be the same. Selecting the Tie button in Input Ch 1 or Input
Ch 2 will tie the two control together. Selecting the Tie button in Input Ch 3 or
Input Ch 4 will tie the controls for these channels together.
Click the Default button to return to the default value.
Click the Invert button to invert the phase of the audio content.