Mixer a menu – Ensemble Designs BrightEye 71 HD/SD 8 Channel Analog Audio Embedder/Disembedder User Manual
Page 14

www.ensembledesigns.com
BrightEye 71 and 71-F - Page 14
HD/SD 8 Channel Analog Audio Embedder/Disembedder User Guide
TM
BrightEye 71 and 71-F
Mixer A Menu
• Outputs 1-4 – provides peak/VU status, with the same methodology as the front panel VU
indicators, but on a per-channel basis, rather than per- channel pair. Peak/VU indicators
illuminate red when the audio level on that channel exceeds the headroom level set by the
user (with the Peak Indicator control.) Additionally, the VU indicator illuminates orange when
the output is above 0 VU, illuminates green when the output is above -20 VU, and doesn’t
illuminate when the output is below -20 VU.
• Inputs Ch 1-4 – these controls provide mixing and output level control for audio channels
1 to 4 of the selected audio group. The text field at the top of the control indicates the amount
of gain applied to the channel in dB. The gain level can be adjusted by moving the vertical
slider control, using the up down arrows, or entering a desired level directly in the field (from
-70 dB to +12 dB.) On the right- hand side of the control are Out Bus Ch Assign buttons. These
buttons control which analog output channel the audio channels are mapped to. It is possible
to map an Input channel to anywhere from zero to eight output channels.
The Tie function is used for stereo operation where gain of a pair of channels is usually desired
to be the same.
The Default button resets the gain to unity (0 dB).
The Invert button allows inversion of a channel to permit phase correction.
When an audio channel is a non-audio data signal, the controls on the Mixer A or Mixer B
menu will be grayed out