Ensemble Designs 5230 Digital to Analog Video Converter and Disembedder - Manual (Page 7)

5230/6230-7
Model 5230/6230 Video Audio DAC
1
6
+
+
+
+
-
-
-
-
11
AUD 2 AUD 1
AUD 3 AUD 4
AES 3/4 In
5230 DAC
Ref In
SDI In
Analog Audio
Cpst Out 1
Cpst Out 2
Cpst/Y/G Out 1
Cpst/Y/G Out 2
C/Pr/R Out
AES 1/2 In
Y/Pb/B Out
AES 1/2 and 3/4 In – Connect
AES digital audio to the AES 1/2
and AES 3/4 inputs.
Cpst Out 1 and 2 – composite
outputs are present on these
connectors for all formats.
Ref In – Connect a composite
video input (PAL or NTSC) if you
are using an external reference.
Y/Pb/B Out – Connect to Y
(Y/C) or the Pb (component
video), or the B (RGB) output
depending on the type of
output video you are using.
SDI – Connect a serial digital
video signal to the SDI input.
Analog Audio Pinouts
Signal Pins Output
Aud 1 +, –, G 1, 2, 7 Output 1
Aud 2 +, –, G 5, 4, 8 Output 2
Aud 3 +, –, G 11, 12, 9 Output 3
Aud 4 +, –, G 15, 14, 10 Output 4
Analog Audio – Use the Analog
Audio 15-pin D connector for
cabling analog audio outputs
when the 6230 option is installed.
Refer to the pinout diagram and
the table below for cabling infor-
mation.
C/Pr/R Out – Connect to C (Y/C),
the Pr (component video), or the
R (RGB) output depending on the
type of video output you are using.
3 RU Backplane
Cpst/Y/G Out 1 and 2 –connect
to a Cpst, Y (component video),
or G (RGB) output depending
on the type of output video you
are using. These are duplicate
outputs.