Ensemble Designs 5230 Digital to Analog Video Converter and Disembedder - Manual (Page 23)

Use the Timing menu shown below to adjust the following parameters:
• Fine Phase – adjust for proper ScH phase with respect to other sources. If fine
phase will not adjust properly, readjust the horizontal phase by up to ± 2 clocks
until the fine phase falls into place.
• Hor Timing – adjust the horizontal timing of the output signal to place the
leading edge of sync coincident with other sources.
• Vertical Timing – set the vertical timing to a typical setting of 0 lines.
This menu provides a Delay window at the bottom of the screen that will report the total
delay in lines of the module.
Model 5230/6230 Video Audio DAC
5230/6230-23