Eneo PNR-5304/4TB - Manual (Page 58)

Part 3 - Configuration
58
Types of configuration options shown vary depending
on the PTZ functions supported by the camera.
1 2 3 4
5
6
7
8
9
0
Numbers shown below Preset, Scan, Pattern,
and Tour indicate the numbers of configured
functions.
1 Preset
• Use the buttons below to choose a preset
position.
- Directional Buttons ( ):
Used to tilt and pan the camera.
- Zoom ( ): Zoom in and out.
- Focus ( ): Adjust camera focus to far or
near.
- Speed: Specify the camera's panning and tilting
speed.
• Set: Choose a preset number and then enter a
name. This saves the current preset under the
specified preset number and name.
• Go to: Select a preset from the list and then click
Go to to move the camera to the selected preset
position.
• Edit: Used to change the selected preset's name.
• Remove: Used to remove the selected preset.
2 Scan
Used to set up a profile for moving the camera
between two points. At least two presets must be
available in order to use the scan feature.
• Set: Used to set up a scan profile.
- Name: Enter a name for the scan profile.
- Start/Stop: Specify which presets to use as start
and stop points.
- Dwell Time (sec.): Specify how long the camera
will dwell at start and stop positions.
- Speed/Direction: Specify scanning speed and
direction.
• Test: Select a scan profile and then click Test to
test it.
• Edit: Used to edit the selected scan profile.
• Remove: Used to remove the selected scan
profile.