Eneo PNR-5304/4TB - Manual (Page 19)

Part 1 – Introduction
19
1 ID Button
Used to assign remote control ID values.
No additional remote control assignment is
necessary if the system's ID is 0. If the system's ID is
a number between 1 and 9, however, you will need
to press the ID button and then press the system ID
number (1 through 99) on the remote control. The
(remote control) icon will appear on the upper
right corner of the NVR screen (status indication
area) to indicate successful system-to-remote control
pairing. If using multiple systems, it's possible to
control all the units with a single remote control as
long as all the system IDs are 0. For more information
on system IDs, refer to the System Setup on page
36.
2 PANIC Button
Pressing this button commences recording
irrespective of the current schedule.
Press the button again to deactivate Panic Recording
mode.
3 Camera Buttons
Pressing the Camera button while in Live or Playback
mode displays images from the selected camera in
full screen. To select a camera whose channel is made
up of two digits, enter the digits in sequence using
the number keys.
4 STATUS Button
Displays event recording device and network
statuses.
5 LAYOUT Button
2x2 > 3x3 > 4x4
6 PTZ Control Buttons
Used in PTZ mode to zoom in/out on the screen and
to shift focus between a nearby point and a far away
point.
7 REGISTER MODE Button
Used in Live mode to access Camera Registration
mode.
8 THUMBNAIL Button
Used in Playback mode to access Thumbnail Search
mode. Thumbnail Search mode displays thumbnails
of video recordings and allows you to search
recordings based on date and time parameters. (Will
be supported.)
9 CALENDAR Button
Displays a video recording playback screen that
includes a calendar.
0 KEYLOCK Button
Locks out all remote control keys. To unlock, press the
button again.
! SETUP Button
Displays the Live menu in Live mode or Control Area
menu in Search mode. Selecting Top by using this
button in the Control Area menu displays the Search
menu. For more information on the Control Area
menu, refer to Time-Lapse Search on page 64.
Press the button once more to close the menu.
Pressing this button while a camera screen is
selected by pressing the
Enter ($) button in Live
mode displays the Camera menu. Selecting Camera
Registration displays NVR and IP Camera Setup
window.
Pressing and holding this button for 3 seconds
activates One-Touch mode and displays the clip copy
window. If the Search menu is displayed on the top
of the screen, One-Touch mode is not activated.
@ FREEZE Button
Used to pause Live screen.
# LOG Button
Displays system log window and allows you to search
the log.
$ Enter Button
Used to make menu option selections and register
data entries. In addition, pressing this button while
a camera screen is selected by pressing the Menu
button in Live or Playback mode displays the Camera
menu.