Eneo AVU-8/2EC - Manual (Page 8)

8
Set-up To enter the Setup menu, first press the key ”∨” and then ”8” and hold
both for at least 3 sec.
Note: To superimpose the menu, a video image must previously be
connected to channel
hinweis
English The language menu appears on the screen
Italiano
Deutsch
Operation ∧, ∨ Select menu point
• Confirm, select
X Activate (in sub-menu)
Settings in ChANNEL B
main menu ALARM
REMOTE CONTROL
LINE SYNChRONISATION
SCREEN DISPLAY
CLOSE
CHANNEL B MODE Sequential image display; single image display
DWELL TIME Duration of individual sequence images
INPUTS Number of connected inputs
FRAMES Number of full images at output B
CLOSE Leave the menu
ALARM ACTIVATION Channel A, channel B or no alarm switch-on
DWELL TIME Duration of alarm display, where there are several alarms
ALARM DURATION Duration of alarm tone in sec (buzzer)
ALARM-FRAME DWELL ON/OFF of full image display
ALARM SWITCh-ON Type of alarm contact: positive (normally closed), negative (normally open)
CLOSE Leave the menu
REMOTE ON Remote control function is activated (9 pin socket). The alarm function
CONTROL must be switched off in the alarm menu!
OFF Remote control function is deactivated (9 pin socket)
CLOSE Leave the menu
LINE SYN- Close NUMBER Optimising possible in +/- 7 steps
CHRONISATION
SCREEN
NUMBER DISPLAY ON/OFF of individual signal inputs
DISPLAY TIME DISPLAY Sequence duration, only possible in ”AUTO” setting
CLOSE Leave the menu
3.4 Menu settings