Eneo NXC-1404F03W - Manual (Page 26)

26
The Full Manual is available from the eneo web site at
www.eneo-security.com or from the CD supplied with this product.
Further information
Using the Reset Button
Follow the instructions below to reset the Network Camera to the factory
default settings using the Reset button.
1. Switch off the Network Camera by disconnecting the power adapter.
2. Press and hold the Reset button with a straightened paperclip while
reconnecting the power.
3. Keep the Reset button pressed during about 2 seconds.
4. Release the Reset button, and wait for the Status LED to turn off.
5. The network camera resets to factory defaults and restarts after comple-
ting the factory reset.
Caution: When performing a Factory Reset, you will lose any settings you
have saved.
(Default IP 192.168.1.10)