Eneo NXC-1404F03W - Manual (Page 19)

19
DE
EN
FR
PL
RU
• Connecting to the RJ-45: Connect a standard RJ-45 cable to the net-
work port of the network camera. Generally a cross-over cable is used for
directly connection to PC, while a direct cable is used for connection to a
hub.
• Micro SD memory slot: Insert the SD memory card.
• Connecting the power supply: connect the supplied DC 5V power adap-
tor
• Connecting the Wireless using WPS button (NXC-1404F03W)
The NXC-1404F03W supports the wireless function.
Follow steps for a proper operation.
1. Make sure your AP (Access Point) and Operating System support WPS
(Wi-Fi Protected Setup) functions. WPS enables easy setup with compatible
APs.
2. Press the WPS button on the camera for more 2 seconds. You can then
see the Status LED is blinking.
3. Press and hold down the WPS button on your AP (some router/AP will
have a virtual button on their management software instead). Refer to your
AP‘s documentation for details using its WPS functions
When WPS configuration is done, wireless connectivity will be established
and the security encryption, such as WEP or WPA-PSK, will be synchro-
nized with the AP.
As for IP setting, the camera‘s use of DHCP or static IP is determined by
your configuration on the network camera via the web- based configuration
of firmware. The camera‘s default is DHCP for the NXC-1403F03 and NXC-
1404F03W.