Eneo NXC-1404F03W - Manual (Page 20)

20
Network setup
The Network Camera supports the operation through the network. When
a camera is first connected to the network it has no IP address. So, it is
necessary to allocate an IP address to the device with the “Smart Manager”
utility on the CD. (Default IP 192.168.1.10)
1. Connect the Network Camera / device to the network and power up.
2. Start SmartManager utility (Start>All programs>SmartManager>SmartMa
nager), the main window will be displayed, after a short while any network
devices connected to the network will be displayed in the list.
3. Select the camera on the list and click right button of the mouse. You
can see the pop-up menu below.
Notes:
1. WPS may not work if your AP is configured with a „hidden“
SSID.
2. If any WPS-enabled AP is not detected, the camera will search APs for
60 seconds after pressing the WPS button, and if the camera still can not
detect an AP after 1 minute, the wireless setup will be cancelled.
3. If a camera is assigned with a fixed IP outside the AP‘s network seg-
ment, wireless setup will fail.