Ascaso Dream - Manual (Page 13)

3-
. Safety
Important Safeguards
1-. Read all instructions
2-. Do not touch hot surfaces. Use
handles or knobs.
3-. To protect againts fire, electric shock
and injury to persons do not immerse
cord, plugs or (state specific part or
parts in question) in water or other
liquid.
4-. Close supervision is necessary when
any appliance is used by or near
children.
5-. Unplug from outlet when not in use
and before cleaning. Allow to cool
before putting on or taking off parts
and before cleaning the appliance.
6-. Do not operate any appliance with
a damaged cord or plug or after the
appliance malfunctions, or has been
damaged in any way. Return
appliance to the nearest authorized
service facility for examination, repair
or adjustment.
7-. The use of accesory attachments
not recommended by the appliance
manufacturer may result in fire,
electric shock or injury to persons.
8-. Do not use outdoors (this item may
be omitted if the products is
specifically designed for outdoor
use).
9-. Do not let cord hang over edge of
table or counter or touch hot
surfaces.
10-.Do not place on or near a hot gas
or electric burner or in a heated
oven.
11-.Always attach plug to appliance
first, then plug cord into the wall
outlet. To disconnect, turn any
control to “off” then remove plug
from wall outlet.
12-.Do not use appliance for other than
intended use.
13-.Save these instructions.
Before setting the appliance going, the
person installing should read this manual
carefully. The operator should be a
responsible adult.
In the event of any anomaly, contact
your distributor.
Start-up
1-.Check that the electrical voltage is
the same as the voltage showed on
the machine's specifications label.
2-.Fill the reservoir with fresh water (see
picture 1). Check that the water intake
tube is immersed in the reservoir.
Using low mineral water is highly
recommended. Quality of water
affects the taste and quality of the
coffee, in addition to prevent future
breakdowns. Consult us about
optional our filters (decaling
treatment).
3-.Plug it into the mains.
Important:
A) The machine is being used for the
first time or has not been used for
some time.
Change the water in the boiler and
circuit.
1-.Connect the coffee machine with
switch 0/1 1 .
2.-Put the filter holder 7 without coffee
into position and a recipient below.
3-.Turn on the coffee switch 2 and run
approximately half a reservoir.
Attention! Check that the reservoir
has water enough. If the coffee
machine is used without water, the
pump may be damaged.
B) PRIMING.
l If coffee does not come out, when
the machine has not been used for
some time.
l After producing steam
l If there is no water in the reservoir,
the following procedure should be
performed:
1-.Turn on the steam tap 4 with the
coffee machine switched on.
2-.Turn on the coffee switch 2 and
allow the water to come out (one cup)
through the steam tube
5 .
3-.Switch off the coffee function 2 and
turn off the steam tap 4 .
The coffee machine is now ready for
use.
C)After steam has been produced, it is
very important to wait for the pilot light
6 to light again, either to go out or to
perform priming.
FIXED FILTER HOLDER SYSTEM
Step A is unnecessary. Step B and C
are necessaries.
4-
. Preparation of coffee
Please, check your system:
(ground , versatile, pod)
Ground
(Only ground system)
Any type of coffee may be used. For
optimum results, we recommend using
special "espresso" coffee blends as they
provide a suitable grind. If the coffee
comes out very quickly or very slowly,
the type of coffee should be changed
for another ground finer or thicker, and
tamping of the coffee should be
m o d i f i e d a c c o r d i n g t o o u r
recommendations as well.
1-.Switch on the machine using the
on/off switch 1 and place the filter
holder (with the filter) into the group.
2-.Wait for the pilot light 6 to go out
(approx. 1.5 minutes). This means
the coffee machine has reached the
ideal temperature. Turn on coffee
switch
2 and let water come out
by the coffee outlet. Do this before
making the coffee, since this will
remove residues and balance the
temperature to create optimum
working conditions.
3-.Fill the coffee basket (1 or two coffees
according to your requirements), The
filter, once pressed, must be filled to
3/4 of its capacity (see picture 2A).
4.-Clean off the remains of coffee that
have been deposited on the edges
of the filter basket so that it fits
perfectly.
5-.Place the filter holder 7 into the
group 8 starting from the left and
turning towards the right with enough
pressure at the end. (see picture 3)
6-.Place the cup or cups on the tray
grid and switch on the coffee switch
2 .
7-.When the coffee has been
prepared,turn off the coffee switch
2 . To prepare a perfect espresso
should take about 20/25 seconds.
ascaso ascaso
ENGLISH ENGLISH
20 21
Picture 2B
!
Picture 2A
Pictute 1