ARM Electronics NDVR16 - Manual (Page 34)

4. TCP-IP SETUP
ADVANCED SETUP PAGE TCP-IP SETUP PAGE
1. ALARM SETUP 1. IP ADDRESS
2. MOTION SETUP 000.000.000.000
3. RECORD SETUP 2. GATEWAY
4. TCP-IP SETUP 000.000.000.000
5. PASSWORD SETUP 3. SUBNET MASK
6. HDD FORMAT 000.000.000.000
7. HDD AUTO DETECT 4. MAC ADDRESS
8. FACTORY DEFAULT 000.000.000.000
> TCP-IP SETUP
-IP ADDRESS
Press direction buttons up/down/left/right to
192.168.192.250 0080 (Factory Default)
TCP-IP items position.
-GATEWAY
192.168.192.001 (Factory Default)
Press values change button to change values.
-SUBNET MASK
255.255.255.000 (Factory Default)
-MAC ADDRESS
XXXXXXXXXXXXX. Machine number, user cannot change.
>Network Requirement:
LAN (Local Area Network)
1) DVR side input local IP address such as 192.168.0.5, or use the factory default IP.
2) After DVR network setting, install the remote viewer to computer. Computer network IP also need to
setup on local IP address such as 192.168.0.6. DVR and computer IP address cannot equal.
-Always 0080 port.
WAN (World Area Network)
1) User apply fixed IP from network, then input IP Gateway, and Subnet mask address to DVR TCP-UP setup.
2) Advice user apply network speed Upload 512K / Download 512K, to avoid image data too big influence the
remote quality. The network traffic jam always make data transfer slow, it is normal.
3) After DVR TCP-IP setup, install the remote viewer to computer. See the remote viewer page.
-Port is depend on network company area, but normally is 0080 port.
34