ARAG ORION Tank filling system - Manual (Page 10)

10
4.3.3 Mode 0 - Mode 2 Use
1 2
3 4 5
1) After start-up the amount of fluid to be poured into the tank is displayed.
2) To start the filling procedure, keep
tOt key pressed until the message "StRt" appears; the value corre-
sponding to the total amount of fluid poured into the tank is displayed in real time.
3) By pressing the
tOt key the instant rate value of the fluid poured into the tank is displayed, preceded by
"lit" (or "gal"). By pressing the key again, the display goes back to indicating the quantity of fluid poured
into the tank.
4) Once the set value has been reached, the message
"end" is displayed, alternated with the total quantity
of fluid poured into the tank. The device will stop automatically the flow into the tank once the set quantity of
fluid is reached.
4.3.4 Interrupting/Stopping before reaching the programmed amount
1 2 3 4
1) During the filling process, you can temporarily stop the pump by pressing ReSet key; "StRt" screen
appears.
If the instantaneous quantity is displayed,
"StRt" screen does not appear: in this case, press tOt key to
display it.
2) To resume loading, press
ReSet key again.
3) To complete loading before reaching the set value, press the keys simultaneously until "end" screen
appears.
4) The count will end and the display will show the programmed amount of liquid.