Allmand Brothers MAXI LITE II - Manual (Page 32)

MAXI-LITE II 3-7
3 To adjust each light fixture, manually swivel each
fixture at its base into the working position you want.
There are two adjustments per light. The fixture and
bracket assembly rotates on the pivot point where it
attaches to the bar and the light fixture rotates
within the bracket.
ROTATING THE TOWER ARMS
With the light tower fully lowered and the lights off, the
light bar assembly and light fixtures can be manually
rotated into the position you want.
Each arm of the light tower needs to be independently
rotated (to ~less than 90 degrees) while the tower is
down.
To rotate the tower arms:
1 Push the “near” end of the arm UP, and then pull the
“far” end DOWN. This means that the end of the bar
closest to the back of the trailer is near the bottom
when you extend the light tower up.
On each arm, this is done with the black handle.
Loosen the handle, rotate the arm then, when
tightening, pull OUT on the handle to rotate it
around the obstruction on the arm, then push in to
continue tightening.
RAISING AND LOWERING THE LIGHT
TOWER
Before operating the tower lights, review “ SAFETY
PRECAUTIONS ” on page 2-2. The light tower is raised
and lowered by a hydraulic pump.
\
Before raising the light tower, adjust the tower lights to
the work position you want.
To raise the hydraulic tower:
1 If required, start the engine. See “ STARTING THE
ENGINE ” on page 3-8 for starting procedure.
2 Turn the lights off. Refer to “ TURNING ON THE
LIGHTS ”.
3 Press the light tower hydraulic lift switch UP to raise
the light tower to the desired height.
NOTICE
Note that there are two adjustments for each
individual light: you can rotate the bracket or you can
rotate the light itself within the bracket.
All necessary adjustments need to be made before
raising the tower.
WARNING
ROLLOVER HAZARD
Before raising, lowering, or operating the tower
lights, the trailer must be set up, properly leveled and
stabilized, and the ground rod installed. Refer to
“ WORK SITE CONSIDERATIONS ” section on page 3-2 .
WARNING
CRUSH HAZARD
Allow adequate clearance around and above the
trailer when raising or lowering the light tower.
Ensure that there are no obstructions or persons near
the light tower when raising or lowering it.
NOTICE
The hydraulically actuated light tower uses 12VDC
battery power to operate. The light tower may be
raised and lowered, as needed, without the engine
running.
NOTICE
Before raising the light tower, visually inspect the
equipment for damage or wear, and repair or replace
components as required. Never operate the light
tower with damaged or malfunctioning components.