ACTi Streaming Explorer V.2.1.09 - Manual (Page 7)

www.acti.com
Streaming Explorer User’s Manual
7
To use PTZ function on PTZ devices or speed domes, you need to configure PTZ related settings
or select a protocol file and click “Enable PTZ” button to use PTZ function and advanced setting.
After PTZ is enabled, the settings of PTZ Operation, Iris/Focus, OSD, Preset and Tour will be
shown as below.
Fig. 5 PTZ Setting
1. Vendor: Select the vendor of PTZ devices or speed dome. Default: ACM-8211
2. Protocol: Select the protocol type of PTZ device/speed dome. Default: VISCA
3. Protocol File: Click on the column to invoke explorer to choose the correct protocol file
4. Address ID: Enter address ID by device setting. Default value:1
5. Parity: Select the type of parity . There three types which are N81 (default value), E81, or O81
in the drop down list. Please check hardware manual for parity setting information.
6. Baud Rate: Select Baud Rate of the device. In the drop down list, Baud Rate can be 1200,
2400, 4800, 9600 (default value), 19200, 38400, 57600, 115200, or 230400. You should
consult hardware manual for baud rate setting information.
7. Enable PTZ: click this button to enable PTZ function
8. Disable PTZ: click this button to disable PTZ function