ACTi Streaming Explorer V.2.1.09 - Manual (Page 13)

www.acti.com
Streaming Explorer User’s Manual
13
Fig. 13 Setting up motion detection
1. Motion Enable: Click this check box to enable motion detection.
Note: If user doesn ‟t click it, motion activity will not trigger motion detection even though you
may have previous settings memorized.
2. Motion Detection regions 1 – 4 .
I. Click the check box and the corresponding region will be enabled.
II. Enter Sensitivity value of the motion detection. The higher the value, the more sensitive
the detection.
III. Enter Timer value of the motion detection. This value is the amount of time before the
next motion detection can be triggered.
IV. Click and Drag the red rectangle on the preview screen to set up the area that user wish
to detect motion in.
NOTE: Most devices provide only three motion detection regions. For these devices the
motion detection window number 4 will be disabled.
3. PIR setting:
I. Click the check box to enable PIR setting
II. Enter Sensitivity value of PIR detection. The higher the value, the more sensitive the
PIR detection.
III. Enter Timer value of the PIR detection. The value is the amount of time before the next
PIR can be triggered.