Step 4: install the camera – ACTi Bullet Camera (E44~E46) on Tilted Wall with Integrated Bracket User Manual
Page 13
Installation Guide
4.
Attach the clamping nut to the main body.
5.
Do the same procedures on the network cable side. Below is a complete cable connection.
Step 4: Install the Camera
1.
If the cables will pass through the wall, push the cable through the hole on the wall.
2.
Attach the camera to the surface using the three (3) supplied screws. If the cables will be
routed along the wall, be sure to route the cable through the gap of the bracket.
This manual is related to the following products: