Epson POWERLITE CINEMA 200 - Manual (Page 37)

37
■ Input Signal
Adjust these settings for the type of equipment connected to the projector:
Video Signal : Leave this setting on Auto so the projector can automatically interpret
the picture (only affects images displayed through the Video or S-Video port).
Input A : Change this setting to match the type of equipment connected to the Input A
port. If necessary, check the label on your equipment to match the setting.
D4 : Change this setting to match the type of equipment connected to the D4 port (used
mainly in Japan).
■ COM Port
Select the type of cable you’ve connected to your PC or laptop for running the Cinema
Color Editor software. Choose
USB or RS-232C (for a serial cable).
■ Trigger Out
Turn on this setting if you want the Trigger out port to output a 12-volt signal while
the projector is operating. You can use this to raise or lower your projection screen
automatically.
■ Sleep Mode
Turn off this setting if you don’t want the projector to enter sleep mode. (Sleep mode
shuts the projector off automatically after 30 minutes when there is no video signal.)
Leave the setting on to conserve power and extend the life of the lamp.
■ Lock Setting
Lets you lock the projector’s focus and zoom settings. Also lets you lock the buttons on
the projector’s control panel, or set a child lock that makes it more difficult to turn on the
projector. See page 25.
Setting ! Input Signal
Setting ! Operation ! COM Port
Setting ! Operation ! Trigger Out
Setting ! Operation ! Sleep Mode
Setting ! Operation ! Lock Setting