Westermo MRD-315 - Manual (Page 5)

5 6623-2250
For Vehicles equipped with an airbag
An air bag inflates with great force. DO NOT place objects, including either installed or
portable wireless equipment, in the area over the air bag or in the air bag deployment
area. If in-vehicle wireless equipment is improperly installed and the air bag inflates,
serious injury could result.
Blasting areas
Do not use the unit where blasting is in progress or in “blasting areas”. Observe
restrictions and follow any regulation or rules.
Explosive atmospheres
Do not use the unit in any area with a potentially explosive atmosphere. Potentially
explosive areas are often, but not always, clearly marked. They include fuelling areas such
as petrol stations, below decks on boats, fuel or chemical transfer or storage facilities,
and areas where the air contains chemicals or particles, such as grain, dust, or metal
powder.
RF energy
The unit is a low power radio transmitter and receiver. When it is ON, it receives
and also sends out radio frequency (RF) signals. Most modern electronic equipment is
shielded from RF signals. However, certain electronic equipment may not be shielded
against the RF signals from the wireless unit. All radio-transmitting devices send signals,
which may cause interference in different electronic devices. To avoid interference, place
the units antenna a sufficiently long distance from other electronics.
Critical applications
Cellular units operate using radio signals and cellular networks cannot be guaranteed to
connect in all conditions. Therefore you should never rely solely on a wireless device for
essential communications, for example medical emergencies.
Backup copies
Remember to make backup copies of all important data, for example PIN/PUK codes,
contents of SIM card etc.
Antenna care
Use only the supplied or an approved replacement antenna. Unauthorized antennas,
modifications, or attachments could damage the unit and may violate current regulations.
Do not touch the antenna unnecessarily when the unit is in use. Contact with the
antenna affects call quality and may cause the unit to operate at a higher power level
than otherwise needed.
Maintenance
No maintenance is required, as long as the unit is used as intended within the specified
conditions.