Westermo MRD-315 - Manual (Page 19)

19 6623-2250
too low for a connection.
When the unit is first switched on, or is reset the indicator will first light red, then flash
red in sequence with the Status Indicator, this is normal behavior during boot-up and
does not indicate a fault.
Factory Default Reset Switch
The reset switch is used to restore the configuration of the MRD to factory default
settings. The switch is accessed through a small hole on the rear of the unit adjacent to
the power connector.
To reset the configuration:
• Power down the unit.
• Use a suitable tool and depress the reset switch.
• Power up the unit ensuring the switch remains depressed for approximately 10
seconds after power is applied. The STS LED and NET LED will flash twice to indicate
a reset.
• The router will now re-boot as normal with the factory default settings.
Note: Using the Factory Default Reset Switch will erase all existing configuration settings
and restore the factory default settings. This includes the network connection
profile settings APN, user name and password.
Factory default reset switch