Westermo AD-01 - Manual (Page 18)

18 6612-2202
AD-01 and connection to SIOX networks
AD-01 can be used to connect a M-Bus network to a sIOX network.
Consider the following points.
• AD-01 can be used transparently, no addressing or set up of AD-01 using the M-Bus
protocol is necessary.
• The primary address should be set to 0 to avoid addressing of the AD-01 unit.
• AD-01 should only be used in datarate using protocol mode since autobaud is not pos-
sible when receiving sIOX commands.
AD-01 to extend a network with a modem link
Two AD-01 units can be used to extend an existing network with any type of modem
link.
Consider the following points.
• AD-01 can be used transparently, no addressing or set up of AD-01 using the
M-Bus protocol is necessary.
• The primary address should be set to 0 to avoid addressing of the AD-01 unit.
• Observe that if a dial-up modem is used the supervision system needs to send dial
commands to the modem. The supervision system must also control that a link is
established before sending data over the link.
RS-232 SIOX
AD-01
M-Bus
SIOX master