Westermo AD-01 - Manual (Page 12)

12 6612-2202
S2 Processor mode
S2 Factory default mode
Factory settings
S2 M-Bus slave mode
Flash mode
Reset to factory default
s2
M-Bus slave used
Normal mode
Normal mode
M-Bus slave not used
Flash mode implies that an update of the application program is possible using the
serial port. see chapter program update.
Disconnected power to AD-01.
set switch to factory default.
Repower AD-01, the unit is now set as factory default.
Disconnect power and set switch to normal mode.
M-Bus slave mode specifies if the M-Bus slave interface is used or not.
ON
1 2 3 4 5
ON
1 2 3 4 5
ON
1 2 3 4 5
ON
1 2 3 4 5
ON
1 2 3 4 5
ON
1 2 3 4 5
ON
1 2 3 4 5
ON
1 2 3 4 5 6 7 8
s1