Westermo FDV-206-1D-1S - Manual (Page 10)

10 6660-2201
USB
Electrical specification
USB 2.0 host interface
Data rate Up to 12 Mbit/s (full-speed mode)
Circuit type SELV
Maximum supply current 500 mA
Isolation to Power, DSL, Ethernet
Galvanic connection to Serial, Console
Connection USB receptacle connector type A
I/O / Relay output
Connect resistance
30 Ω
Isolation to All other
Connection Detachable screw terminal
Connector size 0.2 – 2.5 mm² (AWG 24 -12)
Maximum voltage/current 60 VDC / 80 mA
I/O / Digital input
Voltage levels
Logic one >12V, Logic zero <1V
Isolation to All other
Connection Detachable screw terminal
Connector size 0.2 – 2.5 mm² (AWG 24 -12)
DSL
Electrical specification
See standard table below
Data rate 250 Mbit U/D, limited to 100 Mbit
Protocol EFM (VDSL2), LLC/VC-MUX encap Ethernet (ADSL), PPPoE
(ADSL / VDSL2)
Isolation to All other
Connection RJ-11
Shielded cable Not required, except when installed in Railway applications as
signalling and telecommunications apparatus and located close
to rails.*
Number of ports 1
Standard Annex
ETSI TS 101 270 N/A
ITU-T 993.2 (VDSL2) A, B, J
T1.424 N/A
ITU-T G.992.1 (ADSL) A, B (non overlap)
ITU-T G.992.2 (ADSL lite) A (non overlap)
ITU-T G.992.3 (ADSL2) A, B, I, J, L, M (non overlap)
ITU-T G.992.5 (ADSL2+) A, B, I, J, M (non overlap)
ANSI T1.413 N/A
* To minimise the risk of interference, a shielded cable is recommended when the cable is located inside 3 m
boundary or the cable is longer than 30 m and inside 10 m boundary to the rails and connected to this port.