Welltech LP-389 v.1.06 Administrator Guide - Manual (Page 4)

Fig.2
Change Default IP Network:
Step 3: After successfully logon to the system, we need to change the
network configuration. Click Device Setting > Network to setup the
Interface parameters. First, you need to select the IP supported mode which
could be IPV4/IPV6 dual stack, IPV4 only or IPV6 only. Since IPV6 address is
getting from router advertisement plus the MAC address and cannot be
changed, there is no need to set it up. You can tell the IPV6 address by the web
page. For IPv4, please enter the deserved IP address, netmask and default
gateway or selected to “DHCP”. Apply the change by clicking Apply button as
fig (Fig.3)
(Fig.3)
P.S. If DHCP is used, you can use LCD to know the IP address used.
Change Default Time setting:
Step 4: When re-logon to the new IP address, the next is to setup the system
time zone. Click Device Setting > Time to setup the system. Enter the
4