Welltech LP-389 v.1.06 Administrator Guide - Manual (Page 23)

Dialing Plan > General
Parameter Description:
z Inter Digit Time Out: If you are not using or match the dialed plan
setting, the inter-digit time out can be used as the completion of
dialing.
z End of Digit: The assigned key will be tread as end of dial.
Dialing Digit Plan:
The dialing plan is used to speed up the dialing procedure. LP600 will use the
following rules to decide when will make the call out:
1. Dialed digits prefix is matched the Dialing Rule’s “dialed prefix” and the
input dialed length is matched the “max digits”.
2. End of Digit is pressed
3. Inter Digit Time Out is occurred.
Dialing Plan > Dialing Rule
Dialing rule is used to speed up the dialing procedure. Some user don’t like to
use the end of dialing digit such as “#”, the administrator can use dialing rule
instead.
Parameter Description:
z Dial Prefix: Dialing prefix. The longest prefix will be matched first. For
example, you have 0 (length 10) and 00 (length 16) prefix, when you
dial 09xxxx, LP600 will collect 10 digits as the called number. Instead,
if the user dials 002xxxxx, LP600 will try to collect 16 digits before
sending it out.
z Max Digits: maximum digits to be collected.
Digit Manipulation:
Digit Manipulation is used to modify the called number after user
finished the dialing procedure and speed dialing replacement.
Dialing Plan > Digit Manipulation
23