Wavecom W74PC V8.7.0 - Manual (Page 69)

WAVECOM Decoder W74PC, W-PCI/e, W-CODE, W-CLOUD Manual V8.7.0 First start

59
Right (PCM) or Left & Right (IQ)
Sampling Rate [Hz] The sampling rate is fixed at 48 kHz
Note: If the GUI is running in remote mode, the names of the sound cards installed on the remote com-
puter which hosts the WAVECOM decoder are listed.
Add a new TCP/IP Custom Input
Select the Configuration | Custom Inputs... menu entry to open the configuration dialog for the custom
inputs.
To use a TCP/IP stream as signal input source, the following parameters have to be set via the Custom
Inputs dialog:
Input Parameter Value
Input Name The name of the custom input
Device Select Network in the list
Port number Enter the a port number. The data source must be configured with the same port num-
ber
Format IP-CONF, IP-PXGF or VITA-49 (for more information, see “ WAVECOM Data Formats ”
on page 321)
Sampling Rate (Hz) The sampling rate used by the data source
Number of channels Number of channels
Channel In the list box the channel(s) to be used are displayed: Mono, Left, Right, Left +
Right (PCM) and Left & Right (IQ).
Add a new VITA-49 Custom Input
VITA-49 is a standardized stream format which is specified in ANSI/VITA-49.
To use a TCP/IP stream with VITA-49 format as signal input source, the following parameters have to be
set via the Custom Inputs dialog: