Watson-Marlow 5O5XY Robot - Manual (Page 6)

Step to Stop and press Enter.
L I N E - 2 D I R E C T I O N
H I G H = C W
Press Enter at CW. The pump can be set to operate in a counter-clockwise
or clockwise direction for this setup procedure. The following screens will
then be called:
L I N E - 1 H I G H = S T O P
L I N E - 2 H I G H = C W
B A U D = 9 6 0 0 A U X I L
P U M P = 1 M A X >
Press Main Menu calling up the display:
D D S E C A L M A N U A L
N E T W O R K S E T U P
The 505Di can now be calibrated and the dosing parameters set in the
normal way. (For more information reference the 505Di operating instruction.
It is a recommended that a trial run of the 505XY setup is completed before
full process operation. This will ensure that the traversing limits of the 505XY
have been programmed correctly. (Refer to Part 5 of this operating
instruction).
Following calibration and dose setup the pump screen will indicate:
* * * * M L * * * * * D O S E
P R E S S S T A R T
The GO button can then be pressed on the 505XY Robot and dispensing will
commence.
The 505Di should be set up normally as if for a manual dispensing run. The
505XY robot filler controls when the pump should start dispensing ensuring
that the pump will always wait for the dispensing head to finish moving to the
next position before it starts pumping again.
Note: If the 505Di setup is complete and the pump is ready to start a
dispensing cycle, turning the mains power of the 505XY robot on or off will
initiate a single dose from the 505Di.
6