Watson-Marlow 5O5XY Robot - Manual (Page 3)

505XY one-year warranty
Watson-Marlow Limited warrants, subject to the conditions below, through
either Watson-Marlow Limited, its subsidiaries, or its authorised distributors,
to repair or replace free of charge, including labour, any part of this product
which fails within one year of delivery of the product to the end user. Such
failure must have occurred because of defect in material or workmanship
and not as a result of operation of the product other than in accordance with
the instructions given in this manual.
Conditions of and specific exceptions to the above warranty are:
· Consumable items are excluded.
· Products must be returned by pre-arrangement carriage paid to Watson-
Marlow Limited, its subsidiaries, or its authorised distributor.
· All repairs or modifications must have been made by Watson-Marlow
Limited, its subsidiaries, or its authorised distributors or with the express
permission of Watson-Marlow Limited, its subsidiaries, or its authorised
distributors.
· Products which have been abused, misused, or subjected to malicious or
accidental damage or electrical surge are excluded.
Warranties purporting to be on behalf of Watson-Marlow Limited made by
any person, including representatives of Watson-Marlow Limited, its
subsidiaries, or its distributors, which do not accord with the terms of this
warranty shall not be binding upon Watson-Marlow Limited unless expressly
approved in writing by a Director or Manager of Watson-Marlow Limited.
Safety
In the interests of safety, this unit should only be used by competent, suitably
trained personnel after they have read and understood this manual, and
considered any hazard involved.
Any person who is involved in the installation or maintenance of this
equipment should be fully competent to carry out the work. In the UK this
person should also be familiar with the Health and Safety at Work Act 1974.
Do not place any part of the body within the working envelope of the 505XY
during operation.
There are dangerous voltages (at mains potential) inside the unit. If access is
required, isolate from the mains supply before removing the cover.
Information for returning the robot
Any equipment which has been contaminated with, or exposed to, body
fluids, toxic chemicals or any other substance hazardous to health must be
decontaminated before it is returned to Watson-Marlow or its distributor.
A certificate (a suitable blank form is included at the rear of these operating
instructions), or signed statement, must be attached to the outside of the
shipping carton.
This certificate is required even if the equipment is unused. If the 505XY has
been used, the fluids that have been in contact with the 505XY and the
cleaning procedure must be specified along with a statement that the
equipment has been decontaminated.
3