Watson-Marlow 5O5XY Robot - Manual (Page 13)

D R I P D E L A Y 0 . 1 S
A C C E P T Q U I T
The previously entered drip delay (if any) will be shown. Enter the drip delay
in multiples of 0.1 seconds and press either the ACCEPT button to store the
new value, or the QUIT button to return to the previous setup/fill/options
menu without making any changes.
NOTE: Using the QUIT button provides quick verification of drip delay.
Press the NEXT to call the display:
S E T U P F I L L O P T I O N S
S P E E D M O D E N E X T
P R E S S E N T E R T O R E T
S P E E D M O D E N E X T
The option to return to the previous setup/fill/options menu will also toggle
with this display.
Press the SPEED button, the display will show:
S E T P O S I T I O N E R S P E E D
X . X C M / S N E X T A C C E P T
Use the NEXT button to select the desired filler head traversing speed.
Options of 6, 9 or 12cm/s are available. Press the ACCEPT button to store
the selected speed and return to the previous setup/fill/options menu.
Setting the operating mode
There are two modes of operation with the XY robot. Batch mode is where the
XY robot will perform a fill sequence and then stop, whilst continuous mode is
where the XY robot will repeat its fill sequence until stopped manually.
Press the MODE button, the display will show:
B A T C H M O D E
N E X T A C C E P T
Press the NEXT button to change the operating mode to continuous. Press
the ACCEPT button to store the selected mode and the previous
setup/fill/options menu will be displayed.
Press the NEXT button, the display will show:
13