Watson-Marlow Bredel 40 - Manual (Page 25)

COMMISSIONING
25
6 COMMISSIONING
6.1 Preparations
1. Connect the electric motor in conformance with
the locally applicable rules and regulations.
Ensure that the electrical installation work is
carried out by qualified personnel.
2. Check that the lubricant level is above the
minimum level line in the inspection window. If
necessary add Bredel Genuine Hose Lubricant
via the breather/vent plug. See also §
7.4 .
3. Check the rotation direction of the rotor.
4. Check that the correct number of shims
corresponds with your application. Refer to
§
10.1.7 .
For adjusting the compression force of the
hose, refer to §
7.8 .
6.2 Commissioning
1. Connect the pipework. Make sure that there are
no obstructions such as closed valves.
2. Switch on the hose pump.
3. Check the rotation of the pump rotor.
4. Check the capacity of the hose pump. If the
capacity differs from your specification, follow
the instructions in chapter
9 or consult your
Bredel representative.
5. Check the hose pump in accordance with points
1 to 4 of the maintenance table from §
7.2 .