VXL Instruments Itona TC61yy Series - Manual (Page 17)

13 Removing the Power Supply Unit
8
Removing the Power Supply Unit
To replace the power supply unit:
1. Disconnect the ATX power supply cable as shown in the Figure 19.
Figure 19: ATX Power Supply
2. Using the star screwdriver ( Item B in Figure 1), unscrew the three screws holding the power
supply unit as shown in Figure 20: AC
Figure 20: AC Power Unit Screws
Note: Do not remove the earth connection (The green yellow wire).
3. Remove the power supply unit outward as shown in Figure 21