Verilink T1 ESF CSU (34-00309.B) Product Manual - Manual (Page 3)

iii
Notice to Users
of 1.544 Mbps
Service
The following instructions are provided to ensure compliance with FCC
Rules, Part 68.
1 All direct connections to the network lines must be made using standard
plugs and jacks (compliant with Part 68). The table below presents a list
of applicable registration jack USOCs, facility interface codes (FICs), and
service order codes (SOCs). This information may be required by the
local telephone company when applying for leased line facilities.
2 If the unit appears to be malfunctioning, it should be disconnected from
the network lines until the source of trouble is determined to be your
equipment or the telephone line. If your equipment needs repair, it should
not be reconnected until it is repaired.
3 The unit has been designed to prevent harm to the network. If the
telephone company finds that the equipment is exceeding tolerable
parameters, it can temporarily disconnect service. In this case, the
telephone company will give you advance notice, if possible.
4 Under FCC rules, no customer is authorized to repair this equipment. This
restriction applies regardless of whether the equipment is in or out of
warranty.
5 If the telephone company alters its equipment in a manner that will affect
the use of this device, it must give you warning so that you have the
opportunity for uninterrupted service. You will be advised of your right to
file a complaint with the FCC.
6 If the equipment malfunctions, all repairs should be performed by our
company or an authorized agent. It is the responsibility of users requiring
service to report the need for service to our company or to one of our
authorized agents.
7 The affidavit at the end of this manual must be completed by the installer.
Canadian
Emissions
Requirements This digital apparatus does not exceed the Class A limits for radio noise
emissions from digital apparatus set out in the Radio Interference
Regulations of the Canadian Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques
dépassant les limites applicables aux appareils numériques (de la class A)
prescrites dans le Règlement sur le brouillage radioélectrique édicté par le
ministère des Communications du Canada.
WARNING:For use only with a certified Class 2 power supply. See
Power Source in Specifications on page 2.
WARNING:Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Notice: The Industry Canada label identifies certified equipment. This
certification means that the equipment meets certain telecommunications
Port ID REN/SOC FIC USOC
1.544 Mbps SF
1.544 Mbps SF, B8ZS
1.544 Mbps ANSI ESF
1.544 Mbps ANSI ESF, B8ZS 6.0F 04DU9-BN
04DU9-DN
04DU9-1KN
04DU9-1SN RJ-48C jack