Verilink T1 ESF CSU (34-00309.B) Product Manual - Manual (Page 15)

Introduction 3
2
I
NSTALLATION AND
C
ONFIGURATION
Introduction
This chapter contains information and instructions required to
prepare Verilink’s T1 ESF CSU for use. Included are initial
inspection procedures, mounting instructions, configuration
guidelines, connection and powering information.
Safety Summary
This manual contains information and warnings that must be
followed to ensure safe operation and retain the equipment in a
safe condition.
This WARNING sign denotes a potential hazard to the operator. It
calls attention to a procedure or practice that, if not correctly
performed or adhered to, could result in injury or loss of life. Do
not proceed beyond a WARNING sign until the indicated
conditions are fully understood and met.
Units are susceptible to damage caused by static electricity. Use
ESD (electrostatic discharge) precautionary measures, such as
wearing electrostatic grounding straps.
Unpacking and Inspection
This unit is carefully packaged to prevent damage in shipment.
Upon receipt, inspect the shipping container for damage. If the
shipping container or cushioning material is damaged, notify the
carrier immediately and make a notation on the delivery receipt
that the container was damaged (if possible, obtain the signature
and name of the person making delivery). Retain the packaging
material until verifying the contents of the shipment are complete
and the unit has been checked both mechanically and electrically.
If the contents of the shipment are incomplete or, if there is
mechanical damage or defect, notify Verilink. If the shipping
container is also damaged, or the cushioning material shows
signs of stress, notify the carrier of the damage as well as
Verilink. Keep the shipping materials for the carrier’s inspection.
Verilink will arrange for repair or replacement without waiting
for claim settlement.
Supplied Materials
The T1 ESF CSU is shipped from the factory with the following
standard equipment: