Verilink T1 ESF CSU (34-00309.B) Product Manual - Manual (Page 2)

ii
Copyright Notice Copyright © 2002 Verilink Corporation. All rights reserved. No part of this
publication may be reproduced, transmitted, transcribed, stored in a
retrieval system, or translated into any language in any form by any means
without the written permission of Verilink.
Manual Reorder # 34 - 00309.B
May 2002
Trademarks Verilink ® is a registered trademark of the Verilink Corporation.
All other brand and product names used herein are trademarks or registered
trademarks of their respective manufacturers.
Documentation
Disclaimer This document does not create any express or implied warranty about
Verilink or about its products or services. Verilink’s sole warranty is
contained in its product warranty. The end-user documentation is shipped
with Verilink’s products and constitutes the sole specifications referred to in
the product warranty. Verilink has made reasonable efforts to verify that the
information contained herein is accurate, but Verilink assumes no
responsibility for its use or for any infringement of patents or other rights of
third parties that may result. The customer is solely responsible for
verifying the suitability of Verilink’s products for its use. Specifications are
subject to change without notice.
FCC Requirements This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of FCC Rules. These limits are
designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and if
not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the
user is required to correct the interference at his own expense. This device
must also accept any interference received, including interference that may
cause undesired operation. Shielded cables must be used to ensure
compliance with the Class A FCC limits.
WARNING: For use only with a certified Class 2 power supply.
See "Power Source" in Specifications on page 2.
WARNING: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions:
1 This device may not cause harmful interference.
2 This device must accept any interference received, including interference
that may cause undesired operation.
This equipment complies with Part 68 of the FCC Rules. On the rear or
bottom of the unit is a label that contains the FCC registration number and
other information. If requested, provide this information to the telephone
company.