Installation guide, Installation on the tile edge – Upsite 2040 Surface Mount XLarge Grommet User Manual
Page 6
Designer & Manufacturer
(888) 982-7800 www.upsite.com
Installation Guide
Working With Tile
Easy removal of movable grommet side
The movable side of the KoldLok Surface Mount Grommet is designed to
be easily removed. Simply by lifting the grommet edge the joiner bar,
clips will disengage from the stationary frame to allow easy one handed
removal when placed under or adjacent to equipment racks.
Installation on the Tile Edge
If the cable cutout is an edge cut and the installation of the Grommet
will fall within the perimeter of the tile, the foam strip included in the
gasket set must be used.
1. Apply the foam strip to the exposed stringer on the cut side of the
tile to provide an air block between the stringer and the bottom of
the Grommet.
2. Remove adhesive backing strips from both foam strip and grommet
angle strips and adhere to floor by applying solid, downward pres-
sure on all surfaces.
3. Final Positioning
Note: If the cable cutout is an edge cut and the Grommet will over-
lap onto the adjacent tile, then no foam strip is needed. If part,
but not all, of the Grommet edge overlaps the trim material on
the cable cutout (outside dimension of cutout trim is greater than
7 inch x 9 inch but no greater than 8 ¼ inch x 11 inch), the second
layer of gaskets may be required in order to prevent air leakage.
1-
88
8-
98
2-
78
00
w
w
w .
ko
ld
lo
k.
co
m
U.S. P
aten
t No. 6,632,99
9
Internati
onal P
atent P
end
ing
3
1
1-
88
8-
98
2-
78
00
w
w
w .
ko
ld
lo
k.
co
m
U.S
. P
atent
No. 6,6
32,999
Inter
natio
nal P
atent P
ending
2
6