Upsite 1010 Integral Grommet - Manual (Page 2)

2
Designer & Manufacturer
(888) 982-7800 www.upsite.com
Designer & Manufacturer
(888) 982-7800 www.upsite.com
Tools and Preparation Required for Installation
Tools Required:
• Phillips head screwdriver
• Cutting tool (per floor tile manufacturer recommendations)
• Tape measure
• Isopropyl alcohol or equivalent for cleaning
Preparation:
Cutting Raised Floor Tiles
Each raised floor tile manufacturer provides instructions to properly and safely modify their
products. Installers must be familiar with and observe tile manufacturer’s recommendations
with regard to applicable tools, cutting procedures, the design load capacity of the cut tile,
and any additional underfloor support requirements for cut raised floor tiles.
*IMPORTANT: Data center best practices indicate that tiles should not be cut within the
raised floor environment in order to protect equipment from harmful particulates. However,
quick clean up of any debris or loose particulates is always recommended.
Clean the tile and bottom surface of the grommet using an alcohol wipe or a clean cotton
cloth, damp with a solution of at least 50 percent isopropyl alcohol.
HELPFUL TIP: When choosing your cleaning cloth, do not use fabric or paper that will disin-
tegrate or leave particles that could interfere with the adhesive or contribute to airborne
contamination.
Dimensions and Cutting Requirements Inches (W x D) Millimeters (W x D)
Part No. 10097 (3”x60”) - Overall size 60” x 5.998” 610 x 152mm
Maximum cutout size sealed 60” x 4” 610 x 102mm
Usable cable area 60” x 2.5” 610 x 64mm
Product height above the raised floor 1” w/ adhesive option 25mm w/ adhesive option
Part No. 10098 (6”x60”) - Overall size 60” x 9.025” 610 x 229mm
Maximum cutout size sealed 60 ” x 7” 610 x 178mm
Usable cable area 60” x 5.5” 610 x 140mm
Product height above the raised floor 1” w/ adhesive option 25mm w/ adhesive option
Dimensions and Tile Cutting Requirements Inches (W x D x H) Millimeters (W x D x H)
Part No. 1010 & 3030 - Overall size 11” x 8 1⁄4“ x 1 5⁄8“ 279 x 210 x 41mm
Product height above the raised floor 1⁄8” 3mm
Usable cable area 8” x 4” 203 x 102mm
Cut required to install Grommet
in interior of the tile 9 1⁄4” x 6 3⁄4” 235 x 172mm
Cut required to install long side of
the Grommet on the tile edge 9 1⁄4” x 7 1⁄2” 235 x 191mm
Cut required to install short side of
the Grommet on the tile edge 6 3⁄4” x 10 1⁄4 “ 172 x 260mm