Triplett CamView PTZ – PN: 8000 - Manual (Page 21)

Page 19
3.3 Video Monitor Mode/ PTZ Controller Parameter Setting Cont.
3.3.1 Setting PTZ Parameters
(Overview)
In the PTZ controller mode, press
to access settings for the PTZ param-
eters. Press or to move the
yellow cursor, selecting the desired
parameter. Press or to change
the value of the parameter.
After setting the value of the
parameter(s), press to save the
value(s) and exit.
Press to exit without saving.
SET
SET
RETURN
CLOSE
A. Protocol
Move the cursor to “Protocol” and select the protocol used by the camera that
will be controlled. See Specifications for a list of the available protocols.
B. Port
Move the cursor to “Port”. Select the port on the CamView that will be used to
communicate with the camera. RS485 and RS232 ports are available.
C. Baud
Move the cursor to “Baud”. Select the same baud rate that the camera is set
to. Baud rates available for selection: 150, 300, 600, 1200, 2400, 4800, 9600,
19200.
D. Address
Move the cursor to “Address”. Set the value to the address of the camera to be
controlled.