Triplett Fox & Hound HotWire – PN: 3388 - Manual (Page 32)

The following items are included with the HotWire Fox and Hound
HotWire Fox ………………………………….… Part Number 3388-FOX
HotWire Hound …………………………...............Part Number 3388-HOUND
Carrying Case …………………………………… Part Number 10-4300
Instruction Manual ……………………………… Part Number 84-877
Two 2’ Test Leads (1 red, 1 black) ………………..Part Number 79-805
Two 5’ Test Leads (1 red, 1 black) ………………..Part Number 79-806
Two Pointed Probes (1 red, 1 black) …………… Part Number 79-801
Two Flat Probes (1 red, 1 black) ………………….Part Number 79-802
Two Alligator Clips, Modular (1 red, 1 black) …… Part Number 79-803
Two Alligator Clips, Screw-On (1 red, 1 black)….. Part Number 79-813
The HotWire Fox contains 2 internal fuses.
To test the fuses, set the HotWire Fox to it’s CONTINUITY function and short the test leads. The beeper
should sound. If the beeper does not sound, the fuses maybe blown.
To replace the fuses, disconnect the HotWire Fox from any external circuitry, then remove the 4 screws
on the back of the Fox’s case. Lift the front off of the case. Locate the fuses and replace them if necessary.
Reassemble the case.
No additional maintenance of the HotWire Fox and Hound is required. In the event the product is defective
or is damaged, please contact Triplett for repair information.
Page 31
12: Included Items
WARNING:
The fuses should not blow if the product is used properly. If the fuses blow,
it’s likely the product is being misused. DO NOT REPLACE WITH LARGER
FUSES. DO NOT USE THE PRODUCT IF THE FUSES CONTINUE TO BLOW.
DOING SO MAY DAMAGE THE PRODUCT OR INJURE THE USER.
13: Maintenance