Triplett WireMaster HDMI 2 – PN: 3256 - Manual (Page 4)

4
Installing Battery
Remove the Receiver from the bottom of the Transmitter by slid-
ing it downwards (towards the back of the Transmitter). With Re-
ceiver removed, remove the Transmitter battery cover by sliding
it open. Install a 9 volt alkaline battery taking care to position the
lead wires so the battery fits properly in the cavity. Replace the
battery cover.
Using the WireMaster HDMI
Making Connections
Connect one end of the HDMI cable to be tested to the Transmit-
ter and the other end of the cable to the Receiver. The Receiver
may be removed from the Transmitter so it may be used remotely
if the ends of the cable can’t be positioned next to each other. If
testing a patch cable, the Receiver may be left connected to the
Transmitter.
Autoscanning
Set the WireMaster HDMI AUTO/MANUAL button to AUTO. Set
the ON/OFF slide switch to ON while observing the X-Test display.
If the Low Battery indicator is lit, replace the battery before con-
tinuing. The red X-Test LEDs must slowly sequence from left to
right, from 1 to 9, and then reset to 1 and sequence again to 9.
This cycle should repeat until the product is turned OFF. When
first turned ON, the LEDs may not begin the sequence at 1, but
after 9 lights, the product will reset and start the sequence at 1.
Observe the green LEDs on the Receiver. They must sequence
from 1 to 9, in unison with the Transmitter LEDs. If any LED fails
to light in the 1 to 9 sequence, if any more than 1 LED lights at a
time, or if the LEDs light out of sequence, the cable is defective.