Triplett LazerTape 160 – PN: TLT-160 - Manual (Page 10)

LazerTape 160 Users Manual
4. Measuring
Single Distance Measurement
Press to activate the laser. Point the laser at the target to be measured. Press again to trigger the distance
measurement. The distance is displayed in several seconds on the LCD. The laser turns off.
Continuous Measurement & Max and Min Measurement (See Figure E)
The continuous measurement function can be used to find a specific
distance from a target. When activated, a series of 100 measurements i s
t a k e n e v e r y 0 . 5 s e c o n d s , t h e l a t e s t b e i n g d i s p l a y e d o n
t h e 3 r d l i n e ( 1 2 ) o f t h e L C D . T h e M A X a n d M I N v a l u e s
a r e c a p t u r e d a n d d i s p l a y e d o n t h e L C D . T h i s f e a t u r e c a n
b e u s e d t o f i n d t h e s h o r t e s t o r l o n g e s t d i s t a n c e t o a
s u r f a c e ( l i k e a t i n s i d e a n d o u t s i d e c o r n e r s ) .
To activate, press and hold the MAX/MIN button until MAX and MIN
appear in the LCD. To cancel, press the MEAS or CLEAR button.
10
Figure E
MAX
10