Dacor EF42NBSS - Manual (Page 7)

5
Refrigerator Operation
Normal Operating Sounds
Your new refrigerator may make sounds that your old one
didn’t make. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal. Hard
surfaces, such as the floor, walls and cabinets, can make the
sounds seem louder. The following describes the kinds of sounds
and what may be making them.
If your refrigerator is equipped with an ice maker, you will hear „
a buzzing sound when the water valve opens to fill the ice
maker for each cycle.
Your refrigerator is designed to run more efficiently to keep
„
your food items at the desired temperatures and to minimize
energy usage. The high efficiency compressor and fans may
cause your refrigerator to run longer than your old one. You
may also hear a pulsating or high-pitched sound from the
compressor or fans adjusting to optimize performance.
You may hear the evaporator fan motor circulating air through
„
the refrigerator and freezer compartments. The fan speed may
increase as you open the doors or add warm food.
Rattling noises may come from the flow of refrigerant, the
„
water line or items stored on top of the refrigerator.
Water dripping on the defrost heater during a defrost cycle
„
may cause a sizzling sound.
As each cycle ends, you may hear a gurgling sound due to the
„
refrigerant flowing in your refrigerator.
Contraction and expansion of the inside walls may cause a
„
popping noise.
You may hear air being forced over the condenser by the
„
condenser fan.
You may hear water running into the drain pan during the
„
defrost cycle.
Ensuring Proper Air Circulation
In order to ensure proper temperatures, you need to permit
airflow between the two sections. Cold air enters the bottom of
the freezer section and moves up. It then enters the refrigerator
section through the top vent. Air then returns to the freezer as
shown.
Do not block any airflow vents. If the vents are blocked, airflow
will be obstructed and temperature and moisture problems may
occur.
IMPORTANT: Because air
circulates between both sections,
any odors formed in one section
will transfer to the other. You
must thoroughly clean both
sections to eliminate odors. To
avoid odor transfer and drying
out of food, wrap or cover foods
tightly.
Setting the Controls
The control panel is located inside the refrigerator compartment
on the ceiling.
IMPORTANT:
The refrigerator control adjusts the refrigerator compartment „
temperature. The freezer control adjusts the freezer
compartment temperature.
Wait 24 hours after you turn on the refrigerator before you put
„
food into it. If you add food before the refrigerator has cooled
completely, your food may spoil.
NOTE: Adjusting the refrigerator and freezer controls to a
lower (colder) setting will not cool the compartments any
faster.
If the temperature is too warm or too cold in the refrigerator
„
or freezer, first check the air vents to be sure they are not
blocked before adjusting the controls.
The preset settings should be correct for normal household
„
usage. The controls are set correctly when milk or juice is as
cold as you like and when ice cream is firm.
The actual temperature may differ from the display when a
„
door is open for an extended period of time.
NOTE: The factory recommended settings are 0°F (-18°C) for the
freezer and 37°F (3°C) for the refrigerator.
Turning the Refrigerator On or Off
Press and hold the „ POWER ON-OFF key for 2 seconds.
When the refrigerator comes on, the freezer and refrigerator
temperature displays will light.
To turn the refrigerator off, press and hold the „ POWER
ON-OFF key for 2 seconds. The freezer and refrigerator
temperature displays will go dark when the refrigerator is off.
NOTE:
After the refrigerator is turned on, the over temperature audio „
alarm and indicator light will activate every 1½ hours until the
refrigerator and freezer temperatures are below 48°F (9°C)
and 15°F (-9°C), respectively, or until the alarm is turned off.
To turn off the audio alarm and indicator light, see Master
Alarm Reset on page 7.
The „ Power ON-OFF key on the control panel shuts down the
cooling system, fans and compressors as well as the control
panel lights. To turn the power off completely, use the main
power switch located behind the top grille. See page 3.
Over temperature
indicator light