Tri Tool 214B Flange Facer - Manual (Page 17)

17
Model 214B FF (Flange Facer)
92-1503 : Orig. 100923
MAINTENANCE
All components should be cleaned and coated with a light film of oil prior to use.
Use a clean, non-detergent oil, preferably SAE 10 (90 SSU or lighter) or oil which is
specified for the air motor.
If the Model 214B BEVELMASTER ® with the Model 214B FF (Flange Facer) is
operated in the vertical position (cutting head up), the chips and/or other debris
should be removed after each pass has been completed.
Tool life may be severely shortened, unless chips and/or other debris that have
been deposited on the cutting head during the machining operation are removed.
Clean Up
DAILY MAINTENANCE
Visually inspect all parts for damage due to chips, impact or improper use.
Repair or replace broken or damaged parts as necessary.
Wipe the machine clean of cutting fluids, dirt and grime and then coat it with a light
film of oil.