Tri Tool 214B Flange Facer - Manual (Page 11)

11
Model 214B FF (Flange Facer)
92-1503 : Orig. 100923
If the next flange is the same as the previous flange, install the machine onto the ID
of the pipe and go back to “Position and clamp the Model 214B to the….”.
Damaged or worn Tool Bits are evident by increased feed pressure, visual
observations, poor surface finish, etc.
Replace as necessary and follow "Installation of the Tool Bits" later in this
section.
If the next flange is different than the previous flange then follow the sequence
earlier in this section starting with “Configure the machine for the…”.
For changing the Tool Bit refer to the paragraph later in this section “Installa-
tion of the Tool Bits”.
POSITIONING OF THE TOOL HOLDER
Turn the Feed Sprocket clockwise to feed the Tool Holder in.
Tool Holder feed travel is from O.D. to I.D.
ADJUSTMENT OF THE TOOL BLOCK
Loosen the hold-down screws on the Adjustable Slide Rail.
Run the Tool Holder to the most outward position.
Using the Adjustment Set Screws, apply a light force to the side of the Adjustable
Slide Rail so that it is in positive contact with the Tool Holder.
Adjust only those screws that bear directly in line with the Tool Holder.
Tighten the Hold Down Screws to about 12 in-lbs. (1.4 N m) to 24 in-lbs. (2.7 N m).
Finger tight using a hex key.
Using the 1/4” Drive Ratchet, run the Tool Holder to the inward most position.
Note any changes in the feed pressure.
Some drag from the Slide Rails should be felt, but only a very light torque
should be required to move the Tool Holder.