Tri Tool 214B Flange Facer - Manual (Page 13)

13
Model 214B FF (Flange Facer)
92-1503 : Orig. 100923
NOTE:
INSTALLATION OF THE TOOL BITS
To select the appropriate Tool Bits refer to the “Tool Bits” section.
Use of dull or improperly designed Tool Bits or Tool Bits not manufactured
by Tri Tool Inc. may result in poor performance and may constitute abuse
of this machine and therefore voids the Tri Tool Inc. factory warranty.
Slide the Tool Bit into the Tool Bit Holder Slot on the Tool Holder.
Lock the Tool Bit into position with the set screws on the side of the Tool Holder.
Installation of a Tool Bit (1 of 2)
Installation of a Tool Bit (2 of 2)
Tool Bit Set
Screws
Tool Bit
Cutting Edge
(P/N 99-2553
or 92-2554)
Tool Bit Set
Screws
Tool Bit
Cutting Edge
(P/N 99-2555
or 92-2556)