Tri Tool 212B Flange Facer - Manual (Page 16)

16
TRI TOOL INC.
92-0291 : Rev. 921230
CUTTING SPEEDS
The surface cutting speed will be dependent on the type of material being faced.
When facing over a mounting hole pattern in a flange, machine speed should be
reduced to lessen the impact on the cutting edge of the Tool Bit and to prevent
ripping the edge of the holes.
Roughing Cut .030" (.76 mm) maximum depth
Finish Cut .010" (.25 mm) depth
DEPTH OF CUT RECOMMENDATIONS
Smooth Finish
Roughing or Record Finish
Tool Bit Feed Rate
dependent on the flange material and the type of finish required
.026" (.66 mm) Feed
Both Trippers Engaged
.013" (.33 mm) Feed
One Tripper Engaged