Tri Tool 212B Flange Facer - Manual (Page 10)

10
TRI TOOL INC.
92-0291 : Rev. 921230
OPERATION
Read the operating instructions carefully before attempting to operate the Model
212B-FF.
Use eye protection at all times when operating the Model 212B-FF.
Configure the machine for the proper task. (Refer to the Model 212B Operator’s
Manual.)
Attach the Model 212B-FF to the Model 212B. (Refer to the chapter "Attaching the
Flange Facer.)
Position and clamp the Model 212B to the I.D. of the pipe.
Positioning the Model 212B in a tube or pipe
Check for the proper position of the Tool Holder. (Refer to "Positioning of the Tool
Holder" later in this chapter.)
Check for the proper position of the Tool Bit to the flange. (Refer to "To Adjust the
Depth of cut of the Tool Bit.." later in this chapter.)