Tri Tool 103 REP - Manual (Page 16)

16
TRI TOOL INC.
92-0131 : Rev. 960503
Rapid End Prep Machine Mounted on the Adaptor Assembly
First prepare the Model 103 REP TM in the configuration required for the job at hand.
Refer to the Operating Instructions; ‘Select the recommended Pilot Mandrel’.
Loosen the two Cap Screws, which hold the Clamping Plate together.
Remove the part of the Clamping Plate in which the Cap Screws are held.
Install the Model 103 REP TM into the Clamping Plate and reinstall the other part of the
Clamping Plate and tighten the Cap Screws to hold the Model 103 REP TM in place.
SLIDE THE TRACK ADAPTER ASSY ONTO THE CROSS-TRACK ASSY
Slide the Cross-Track Assy along the 64” (1.6 m) Track to the desired location.
Slide the Track Adapter Assy along the 23” (.6 m) Track until the Model 103 REP TM is
located directly over the tube to be worked on.
Rotating the Handle on the REP Adapter Assy will cause the Model 103 REP TM to be
lowered into the end of the tube.
See the Previous Section for the machining operation.